The purpose of this study is to evaluate the amounts of apically extruded 3% sodium hypochlorite using two modes of Er:YAG laser-activated irrigation (LAI), super short pulse (SSP) and shock wave enhanced emission photoacoustic streaming (SWEEPS®), combining three types of laser tips (FT) and conventional syringe needle irrigation (SNI). Methods: Twenty extracted human maxillary central incisors prepared using Reciproc® instruments (size 40, taper 0.06). Irrigant volumetric flow (IVF) was accurately standardized using a precision syringe pump with constant irrigant delivery through the 27G needle. The tested irrigation protocols (60 s) were groups 1: 27-G SNI with 0.05 ml/s constant IVF; group 2: SSP (10 mJ, 15 Hz, pulse duration 50 μs) + Radial SWEEPS FT; group 3: SSP + photon-induced photoacoustic streaming (PIPS) FT; group 4: SSP+SWEEPS FT; group 5: AutoSWEEPS (20 mJ, 15 Hz, pulse duration 25 µs) + Radial SWEEPS FT; group 6: AutoSWEEPS+PIPS FT; group 7: AutoSWEEPS+SWEEPS FT. Each protocol was evaluated in 10 repetitions each. Apically extruded irrigant was collected, and the net weighted. Results: There were significantly lower amounts of extruded irrigant with SNI and SSP using radial SWEEPS and PIPS FTs compared to the other tested laser protocols (p<0.05). In the AutoSWEEPS groups, all three FTs had similar amounts of extruded irrigant (p>0.05). Conclusion: In straight root canals, the use of various fiber FTs in the AutoSWEEPS mode exhibited a higher potential for irrigant extrusion.

Introduction: Obstructive sleep apnea syndrome (OSAS) is characterized by recurrent episodes of upper airway obstruction and involves intermittent hypoxia and sleep fragmentation, with potentially serious consequences for affected patients. (1–3). Although nocturnal polysomnography is the gold standard, it is an exam that is not readily available and is very expensive. (4). Hence, the need to find new diagnostic methods. Considering that the causes of OSAS can be divided into anatomical-structural ones, related to craniofacial anomalies, it has been hypothesized that anthropometric measurements taken by new 3D stereophotogrammetric systems could be useful as a diagnostic tool in pediatric patients with OSAS (5) (6). The primary objective of the study is, therefore, to evaluate the correlation between mandibular length measured between menton and gonion, obtained through 3D stereophotogrammetry using the "Face Scanner maxi 6", and the severity of OSAS (AHI classification), defined by the score of the Sleep Clinical Record (SCR) questionnaire in a group of pediatric patients with suspected obstructive sleep disorders. The secondary objective concerns the identification of possible correlations between other mandibular parameters estimated by 3D stereophotogrammetry and the severity of OSAS, defined by the McGill Oximetry Score (MOS), and the association between MOS and SCR to determine the AHI level. Materials and methods: The study considered patients who were prescribed a pulseoximetry exam due to suspected obstructive sleep disorders. All participating patients underwent a specialized orthodontic examination, which included completing the SCR questionnaire and taking facial photographs using a 3D stereophotogrammetric system. The SCR questionnaire considers 11 dental, nasal, oropharyngeal, and facial phenotype parameters to determine a final score from 0 to 18, indicating the risk of obstructive sleep apnea syndrome. The acquired stereophotogrammetric images were processed using dedicated software to obtain a three-dimensional model representing the patient's facial phenotype. Subsequently, anatomical landmarks and relevant anthropometric measurements were identified on the model, and it was assessed whether one or more of these showed concordance criteria with the parameters derived from SCR and MOS. The anthropometric evaluation was performed by expert operators, taking into account mandibular variables. Results: Fifteen patients were analyzed, with 2 excluded due to alterations in the stereophotogrammetric images caused by poor patient cooperation during the acquisition of the photographs. Spearman's correlation analysis was performed to investigate the relationship between anthropometric measurements, obtained by 3D stereophotogrammetry, and OSAS severity, by means of SCR, MOS, and SCR+MOS. A significant and negative correlation was observed between right mandibular length (gonion-menton) and MOS (ρ=−0.586, p=0.036). Conclusions: The result obtained has important implications for the field of study and suggests that future attention should focus more on the mandibular length variable as a determining factor for OSAS. However, the sample examined was relatively small, which might obscure the correlation with contralateral mandibular length and potential correlations with other mandibular/facial parameters. Additionally, the small sample size prevented stratification by sex and age. The study thus provides an important contribution to understanding the relationships between 3D stereophotogrammetry and pediatric OSAS but also highlights the need for further research that could potentially influence future developments in diagnosing OSAS in children.

(1) Background: This retrospective cohort study aimed to investigate the cephalometric evaluation of facial height ratio (FHR) and growth patterns. (2) Methods: We assessed facial height ratios, Y-axis to SN angle, and growth patterns in 94 participants from Timis county using digital cephalograms. Participants were categorized based on Angle’s classification. Cephalograms were digitally traced and analyzed using WebCeph imaging software. Statistical analysis was conducted using Python version 3.11.9. (3) Results: Significant correlations were observed between FHR and craniofacial development, particularly regarding hypodivergent growth patterns. In a sample of 94, molar classes showed varying patterns: Class I—33.3% hyperdivergent, 61.5% normodivergent, 33.3% hypodivergent. Class II—50% hyperdivergent, 30.8% normodivergent, 52% hypodivergent. Class III—16.7% hyperdivergent, 7.7% normodivergent, 14.7% hypodivergent. Y-axis to SN angle values were within normal limits across groups (Group I: 65.0 (IQR: 61.2-69.0), Group II: 65.0 (IQR: 62.0-69.0), Group III: 67.0 (IQR: 59.7- 69.0). A strong negative correlation was found between Y-axis to SN angle and Jarabak’s ratio (r = -0.72, p < 0.001), highlighting the need for holistic assessment methods in orthodontic practice. (4) Conclusion: Patients from Timis county predominantly exhibit a hypodivergent growth pattern across all malocclusion types. Understanding these patterns is essential for comprehensive orthodontic treatment planning. Further research is needed to explore the implications of these findings on treatment outcomes and patient care.

Background:The association between ABO and Rh blood groups and diseases is an intriguing topic that continues to be studied. However, how mandibular symmetry may vary by blood group has not been investigated. This study explored the relationship between these blood groups and mandibular condyle and ramal asymmetries in the Turkish adult population. Methods:The study included 149 adult patients (67 males and 82 females) without systemic diseases or temporomandibular disorder complaints. Asymmetry was assessed in panoramic radiographic images using a formula developed in a previous study. The chi-square and Kruskal-Wallis tests were used to analyze differences among ABO groups while the Mann-Whitney U test was used for Rh groups. Results:There were no statistically significant differences among the ABO blood groups, nor the Rh groups, in terms of sex, Rh factor, and age distribution. However, a comparison of the ABO and Rh blood groups revealed that condylar asymmetries were significantly more common in the AB group. Conclusions:These results suggest that mandibular asymmetry may be associated with the ABO blood group. These findings may guide future research to gain a deeper understanding of the relationship between mandibular asymmetry and blood groups.

Peri-implant infective diseases seem to be the most common cause for the late dental implant failure. Therefore, peri-implant microbiota has been intensively studied in modern implantology. Many studies showed a presence of extremely varied microflora in cases of peri-implant infective diseases. The main scope of this observational single-blind study was to analyze the presence of some microbial species in a group of patients with clinical signs of peri-implant mucositis compared to two other groups (patients treated with dental implants but without any clinical signs of peri-implant inflammation and patients treated with no dental implants). The identification of microorganisms was followed by an antibiogram in order to find their sensitivity to various antibiotics. The results showed a microbiota not necessarily specific for each situation (peri-implant infective diseases, healthy tissues around dental implants and healthy natural teeth and gums) with species like Candida albicans, Neisseria mucosa, Prevotella, Staphylococcus aureus, Streptococcus and others. Peri-implant infective diseases presented more bacterial species than other conditions.

For dental implant treatment to be successful, esthetics, functionality, and cleanability are all required of the superstructure, the final prosthesis. Screw fixation and cementation have been the conventional methods of choice for the crown prosthesis of implants, but these individual methods cannot fulfill all the requirements. As a solution to this problem, we have devised a new implant superstructure restoration method (inlay covering esthetic technique) using computer-aided design / computer-aided manufacturing inlays. This involves the placement of an inlay covering the access hole in a highly translucent partially stabilized zirconia crown. This technique expands the indications for implant treatment and improves the oral quality of life of patients.