Calicotome villosa is a eurioic legume with broad distribution in the south of Europe. It can grow in almost any type of soils as well as in humid and dry and nutrient deficient ecosystems. The broad distribution and eurioic nature of C. villosa may be attributed to its ability to establish symbiotic associations with plant growth promoting (PGP) bacteria housed in the nodules and rootless. This study examined legume-microbe symbiosis of C. villosa growing in two contrasted locations, hill top with high sun irradiance and drought; and a valley bottom, with low level or radiation and sufficient soil humidity for plant growth. Calicotome villosa adult plants established symbiotic in-teractions with bacteria in six genera, Pseudomonas, Stenotrophomonas, Bacillus, Paenibacillus, Brevicacterium and Rhizobium as well as one uncultured bacteria. Plants growing in the hill top had associated lower bacterial richness than those grown at the valley bottom. All strains were drought tolerant and produced siderophores, IAA, HCN and NH3 that stimulated plant performance in both, C. villosa plants and other four legumes commonly present in the understory of the shrubs communities The legumes’ capacity to selectively host symbiotic bacteria that enhance plant survival in harsh conditions partly accounts for the diverse partnerships between C. villosa plants and their symbionts, ultimately explaining the wide distribution of this plant species.

Information on how bacteria in plants and soil, along with extracellular enzymes, affect nutrient cycling in Encephalartos villosus growing in nutrient-poor and acidic scarp forests is lacking. Bacteria in coralloid roots, rhizosphere, and non-rhizosphere soils were isolated to determine the potential role of soil bacterial communities and their associated enzyme activities in nutrient contributions in rhizosphere and non-rhizosphere soils. The role of soil characteristics and associated bacteria on E. villosus nutrition and nitrogen source reliance was investigated. Encephalartos villosus leaves, coralloid roots, rhizosphere, and non-rhizosphere soils were collected at two scarp forests. Leaf nutrition, nitrogen source reliance, soil nutrition and extracellular enzyme activities were assayed. A phylogenetic approach was used to determine the evolutionary relationship between identified bacterial nucleotide sequences. Twenty, twelve and seven different bacterial genera were isolated from rhizosphere, non-rhizosphere, and coralloid roots, respectively. Phosphorus and nitrogen cycling enzyme activities in E. villosus rhizosphere and non-rhizosphere soils were insignificant. More than 70% of the leaf nitrogen was derived from the atmosphere. This study revealed that plant-associated bacteria with plant growth-promoting functions, soil bacteria, and associated extracellular enzymes play a role in E. villosus nutrition and nitrogen source reliance and contribute to E. villosus rhizosphere and non-rhizosphere soil nutrition.

Land degradation and climate change are among the main threats to the sustainability of ecosystems worldwide. Therefore, the restoration of degraded landscapes is essential to maintain the functionality of ecosystems, especially those with greater social, economic and environmental vulnerability. Nevertheless, policy-makers are frequently challenged by deciding on where to prioritize restoration actions, which usually includes to deal with multiple and complex needs under an always short budget. If these decisions are not taken based on proper data and processes, restoration implementation can easily fail. To help decision-makers taking informed decisions on where to implement restoration activities, we have developed a semiautomatic geospatial platform to prioritize areas for restoration activities based on ecological, social and economic variables. This platform takes advantage of the potential to integrate R coding, Google Earth Engine cloud computing and GIS visualization services to generate an interactive geospatial decision-maker tool for restoration. Here, we present a prototype version called "RePlant alpha" which was tested with data from the Central Zone of Chile. This exercise proved that integrating R and GEE was feasible, and that the analysis, with at least six indicators and for a specific region was also feasible to implement even from a personal computer. Therefore, the use of a virtual machine in the cloud with a large number of indicators over large areas is both possible and practical.

Taking into account the increase in the emission of greenhouse gases produced by ships, during navigation and maneuvering in the port, a direct consequence of the increase in maritime traffic, the international community has developed a broad set of regulations to limit such emissions. The installation in commercial ports of automatic mooring systems by means of vacuum suction cups (AMS), thus reducing considerably the time required to carry out the mooring and unmooring maneuvers of ships, is a factor that is considerably influencing the decrease in Emissions of polluting gases in commercial ports with high traffic. The objective of the present work is to verify the influence of the use of the AMS on the emissions of polluting gases produced in the facilities destined to the traffic of container ships. It examines the CO2 emissions of container ships that call in the only three container ports equipped with AMS: Salalah (Oman), Beirut (Lebanon) and Ngqura (South Africa). Between them, these three ports supported the transit of 6 million TEUS in 2017. The calculation of emissions is made taking into account the time saved when performing the mooring maneuvers using the new AMS system compared with when it is not used. To do this, two different calculation methods are used: EPA and ENTEC to then compare the results of the two and thus obtain the reduction in emissions per TEU in these terminals during the mooring maneuvers. The paper concludes with a discussion on the values of the reductions in emissions obtained and the advantages of the installation of AMS in commercial ports located near population centres.

The different cell subsets of the immune system express vitamin D receptor (VDR). Through VDR, vitamin D exerts different functions which influences on immune responses, as previously shown in different preclinical models. Based on this background, retrospective studies have explored the impact of vitamin D levels on the outcome of patients undergoing allogeneic hematopoietic stem cell transplantation, showing that vitamin D deficiency is related to an increased risk of complications, especially graft-versus-host disease. These results have been confirmed in a prospective cohorts trial, although further studies are required to confirm this data. In addition, the role of vitamin D on the treatment of hematologic malignancies has also been explored. Considering this dual effect both on the immune system as well as on tumor cells in patients with hematologic malignancies, vitamin D might be useful in this setting both to decrease graft-versus-host disease and relapse rates.

In this work, the structural, magnetic, and mechanical properties of Nd16Fe76-xCoxB8 alloys varying the Co content at x = 0, 10, 20 and 25, were experimentally investigated by X-Ray Diffraction (XRD), Mössbauer Spectrometry (MS), Vibrating Sample Magnetometry (VSM) at room temperature (RT), and microhardness test were performed too. The system presents the hard Nd2Fe14B and the Nd1.1Fe4B4 phases for samples with x = 0 and 10. When concentration increases to x= 20 and 25, the CoO phase appears. All MS show the ferromagnetic behavior (eight sextets: sites 16k1, 16k2, 8j1, 8j2, 4c, 4e, sb) associated to the hard and soft magnetic phases, and one paramagnetic component (doublet: site d) associated to the minority Nd1.1Fe4B4 phase, which was not identified by XRD. All samples are magnetically hard present a hard magnetic behavior. The increase of Co content in these samples did not improve the hard magnetic behavior, but increased the critical temperature of the system and decrease the crystallite size of the hard phase. The hysteresis loop showed that predominates the Nd2Fe14B hard magnetic phase. There is a general tendency to increase microhardness with cobalt content, attributable to cobalt doping reduces the lattice parameters and porosities in the sample improving it hardness.

Zirconia-reinforced lithium silicate (ZLS) is utilized as a material for prosthetic tooth crowns, offering enhanced strength compared to other dental glass-ceramics. In this study, we investigate a commercial ZLS material, provided in a fully crystallized form. We examine the effects of an optional post-processing heat treatment on micro-contact damage using controlled indentation tests simulating the primary modes of contact during chewing: axial and sliding. Our findings indicate that the heat treatment does not affect mechanical properties such as the elastic modulus, hardness and indentation fracture toughness. However, it does enhance the resistance to contact damage by fracture and chipping in both axial and sliding modes, as well as the resistance to crack initiation measured from sliding tests. This improvement is attributed to the refinement of the flaw population achieved through the heat treatment. The results are analysed within the framework of contact and fracture mechanics, and the implications for prosthetic dentistry are briefly discussed.