In this paper, a novel voltage control strategy of stand-alone operation brushless doubly fed induction generator for variable speed constant frequency wind energy conversion systems was presented and discussed particularly. Based on the model of the generator power system, the proposed direct flux control strategy employs a nonlinear reduced-order generalized integrator based resonant sliding-mode control scheme to directly calculate and regulated the output value of converter which control winding stator required so as to eliminate the instantaneous errors of power winding stator flux, and no involving any synchronous rotating coordinate transformations. The stability, robustness and convergence capability of the proposed control strategy were described and analyzed. Owing to no extra current control loops involved, therefore simplifying the system configuration design and enhancing the transient performance. Constant converter switching frequency was achieved by using space vector pulse width modulation, which reduce the harmonic of generator terminal voltage. In addition, experimental results prove the feasibility and validity of the proposed scheme, and excellent steady and dynamic state performance is achieved.

Satellite altimetry is successfully developing during the past three decades for the sea level, ocean dynamics, coastal oceanography, planetary waves, ocean tides, wind and wave, ice cover, Earth’s gravity field, and climatology research. We propose a new essential add-on of satellite altimetry related to the peculiarities of the orbits of the Topex/Poseidon and Jasons’ satellite missions which were not mentioned before in the scientific publications. Derived subsets of “self-crossover” and “inter-crossover” points in sub-polar latitudes are discussed in detail in the context of water exchange, and wind-wave dynamics, and potential challenges to be solved. The relatively short time lags between measurements at these crossovers provide additional information on anomalies of magnitudes and directions of ocean currents, and characteristics of wind-driven waves. Resulting data snapshots with constant space and time intervals can be regarded as time series of virtual buoys, an analog of continuous buoy measurements of the sea level, wind speed, and wave height. Areas of the World Ocean where these specific crossovers occur are described in the context of water exchange, wind wave studies, and potential challenges to be solved. The value of these special crossovers for studies and monitoring of the sub-polar seas is illustrated by a case study.

Distracted driving is the leading cause of accidents, the cause of these distractions may include drowsiness, using cell phone, smoking a cigarette, etc. The proposed paper aims at monitoring the attentiveness of the driver and alerting the driver when his/her alertness goes below a certain threshold. It uses image processing using OpenCV (Computer Vision) and You Look Only Once (YOLO) algorithm to detect the eyes and object respectively and sounds an alarm when the driver is either drowsy or using his cell phone or smoking a cigarette.

Can a gravitational lens magnify gravity ? The answer to this question is the subject of this article. Light is deflected as it passes through curved spacetime caused by a mass distribution. This phenomenon, known as "gravitational lensing," has been extensively studied and is well understood. According to the general theory of relativity, the same deflection is expected for gravitational waves, because they also propagate at the speed of light. But this applies to gravitational fields as well. Thus, gravitational fields, which extend through curved spacetime, are also deflected correspondingly. This effect is referred to as "Gravitationally Lensed Gravity". It leads to the fact that the gravitational field strength originating from an object in the background of a gravitational lens is enhanced in the same way as its light intensity. If the background object is visible to an observer several times due to the gravitational lens, each of the images also exerts a corresponding gravitational attraction on her ! For the first time, a proof of the existence of this amazing effect is given. In a simple thought experiment the contraction of a spherically symmetric gravitational lens is discussed. The proof is essentially based on Birkhoff's theorem. According to this theorem, during the contraction additional null geodesics between the background object and the observer come into existence. To these null geodesics also contributions to the gravitational field are to be assigned. In the literature, similar descriptions can be found for the gravitational self-interaction of a particle in a curved spacetime background. The article is organized as follows: In the introduction, the historical origin of the idea of the "Gravitationally Lensed Gravity" is briefly outlined. In the second chapter, the subsequently required basic principles and essential features of general relativity are explained. In the third chapter I analyze different arrangements of masses and describe the observations to be expected. The arrangements show step by step the transition from the classical "Newtonian limit" in a flat spacetime background to the "Gravitationally Lensed Gravity" in a curved spacetime background. Due to its clarity, the simple scenario may also serves as a suitable test case for the mathematical methods of general relativity. The concluding outlook provides references to current questions in astrophysics, especially the question of the existence of Dark Matter. Here, the general theory of relativity offers much simpler explanations with the "Gravitationally Lensed Gravity".

The electrical motor design requires a lot of work and resources. In the field, motor designers need to decide on competitive motor sizing quickly to compete with other motor suppliers. Generally, it requires expensive FEM S/W to get accurate motor sizing results, but buying and maintaining many licenses is costly. Moreover, it needs some patience to get the result from FEM analysis. In this paper, the motor sizing technique using an existing production motor is presented to respond to urgent requests from customers without using FEM analysis. In order to enhance the fidelity of the result, magnetic flux loss by magnet coating and non-linear characteristics are considered during the motor sizing process. The proposed sizing method was verified by comparison to the FEM analysis and test result and showed reasonable confidence in them. Also, this method has the substantial advantage of outputting accurate results instantly without taking any time. It helps with the modification design of electrical motors without using expensive FEM S/W and a certain level of skill or experience.

Combining wind and solar photovoltaic (PV) generation can provide complementary renewable power production, but depends on correlated resources. This study analyzed 10 years of wind data from Naama, Algeria to evaluate the potential for evening wind generation to offset the loss of solar at sunset. Average wind speeds showed a distinct increase during evening hours, coinciding with the decrease in solar irradiance. Wind turbine simulations using a 1.5 MW turbine and the wind data showed sufficient resources for profitable power production after sunset. Statistical analyses confirmed significantly higher wind speeds and simulated power output in evening vs daylight periods (p<0.05). The Pearson correlation coefficient between evening wind speeds and decreasing solar irradiance was 0.63, supporting a strong positive relationship. These findings indicate Naama has adequate wind resources to deploy economically viable wind power capacity that can complement existing solar infrastructure and provide renewable electricity after dark , .

A gravitational lens is mass-curved spacetime. Light that propagates freely, locally always on the fastest way, follows curved paths in it. The same applies to all effects propagating with the speed of light, also to gravity itself. They all have to follow the curvature of spacetime. A gravitational lens not only enhances the light from background objects but concurrently also their gravitational effect ! The "Gravitationally Lensed Gravity" (GLG) is a still scarcely noticed peculiar feature of general relativity. In [1] I presented a thought experiment to make the existence of this effect plausible. Here these considerations are described in terms of future and past light cones or null cones commonly used in relativity theory to illustrate the causal structure of spacetime. In the framework of general relativity, the GLG effect can be understood as a consequence of the folding of the past null cone by a gravitational lens. Starting from the basic ideas of the theory, the terms are introduced and applied. The extensive description on textbook level should be understandable also for beginners. In order not to obstruct the view on the essential physical relations, I avoid a mathematical formalism and use instead diagrams and figures, based on realistic numerical calculations, to reinforce my logical argumentation. Experts will recognize many long-known facts, but may still be surprised by the resulting conclusions. First, I present some particular aspects of the historical evolution of the concept of gravitational lensing and give a brief overview of the work of other authors on the subject GLG. I then explain the limitations of the applicability of the "Newtonian Limit" and move on to the key role of the speed of gravity in understanding GLG. Finally, I use a simple example to illustrate the possible significance of the GLG effect. With this work I intend to elicit greater interest in "Gravitationally Lensed Gravity" and to initiate a broader discussion about it.

The classification of Trojans in modern analog microcircuits is considered. Using high-speed operational amplifiers (Op-Amps) as an example, the relationship between Op-Amp circuit design and the formation of undesirable states in typical switching circuits is shown. Circuit solutions are proposed to minimize the Trojan states of high-speed Op-Amps. These include limiting the maximum output currents of the input stages of the Op-Amp during the transient process and the use of differentiating transient correction circuits in the Op-Amp.

If we assume that: a. The four fundamental forces of nature are independent waves without rest masses, and their speeds are constant in a vacuum, just like light. b. Light or electromagnetic waves and gravity are comparable in structures. Weak and strong interactions are similar in structures. c. Light and weak interaction have the same speed c_L with spin number +1 or –1. d. Gravity and strong interaction have the same speed c_G without spin. e. The primary particles, namely electrons, electron neutrinos, and dark neutrinos in this paper, are made by the above four waves. We can find and describe some fundamental characteristics of the primary particles (e.g., their sizes, energies, and interactions) and introduce new attractive results from them (e.g., the source of the Pauli exclusion principle, the solution to the Einstein-Podolsky-Rosen paradox, and c_G slightly faster than c_L).

The study of emission, propagation, and reflection of balls in Newtonian mechanics, employing the laws of conservation of momentum and energy when the mass of balls converges to zero, concludes that the kinematics of light is like that of massless balls. The kinematics of light explains why light speed is the constant in each inertial frame in which the light source and reflective mirror are at rest, why the laws of physics have the same form in each inertial frame, and why any experiment in an inertial frame cannot prove the motion of that the other inertial frame. The theory of special relativity misapplies symmetry observed in phenomena to two inertial frames; therefore, it duplicates a physics phenomenon from one inertial frame, considered stationary, into another. Moreover, Lorentz’s transformation offers light speed at the constant in the moving and opposite direction of the inertial frame but is variable in any other direction. Therefore, the theory of special relativity rejects itself with these unacceptable conclusions.

The trafficking of illegal drugs by criminal networks at borders, harbors, or airports is an increasing issue in public health as these routes ensure the main supply of illegal drugs. The prevention of drug smuggling, including the installation of scanners and other analytical devices to detect ultra-small traces of drugs within a reasonable time frame, remains a challenge. The presented immunosensor is based on a monolithic affinity column with a large excess of immobilized hapten, which traps fluorescently labeled antibodies as long as the analyte cocaine is absent. In the presence of the drug, some binding sites of the antibody will be blocked, which leads to an immediate breakthrough of the labeled protein, detectable by highly sensitive laser-induced fluorescence with the help of a Peltier-cooled complementary metal-oxide-semiconductor (CMOS) camera. Liquid handling is performed with high-precision syringe pumps and microfluidic chip-based mixing devices and flow cells. The biosensor achieved limits of detection of 23 pM (7 ppt) of cocaine with a response time of 90 seconds and a total assay time below 3 minutes. With surface wipe sampling, the biosensor was able to detect 300 pg of cocaine. This immunosensor belongs to the most sensitive and fastest detectors for cocaine and offers near-continuous analyte measurement.