Elucidating physicochemical processes in the degradation of pollutants may optimize their removal from water sources. This work presents a set of elementary steps in the photocatalytic degradation of carbamazepine (CBZ), assuming a steady state approximation in an Advanced Oxidation Process (AOP) combining short-wave ultraviolet radiation (UVC), homogeneous reagent (H₂O₂) and heterogeneous (TiO₂) catalyst. Elementary steps include excitation of both reagent/catalysts by UVC photons, adsorption of CBZ on the excited TiO₂, or its oxidation by hydroxyl radicals. Assuming the steady state approximation on the intermediate products (excited TiO₂, CBZ- excited TiO₂ complex, and hydroxyl radicals), leads to rate laws for degradation of CBZ, in which UVC radiation, TiO₂, and H₂O₂ are pseudo first order at all concentrations or intensities having no direct influence on CBZ pseudo-order, whereas CBZ shifts from pseudo first order at low concentrations to pseudo-zero order at high concentrations. Several experiments to test the mechanism were conducted, by varying CBZ, H₂O₂, and TiO₂ concentrations, and UVC radiation intensities. Measured results indeed fit the suggested mechanism for the first three, but irradiation intensity appears to shift CBZ influence from pseudo-second to pseudo-first order with increased intensities. Corrected elementary steps are proposed to fit the results.

The final assembly of appliances and automotive industries is a rigorous process, that has limited capabilities of full traceability associated with: (1) the parts installed, (2) their fabrication processes, and (3) the assembly work. This is also the case for each of its sub-assemblies The many parts and sub-assemblies that compose the final assembly, make full traceability a challenging fit, that is almost unsurmountable. Such full traceability along the entire supply-chain is not existent today and must be based on documentation of most assembled parts, assembly tasks, and inspection tasks that compose the full assembled product. In addition, security measures are needed to prevent hostile hacking and unauthorized approach to the assembly documentation throughout the entire supply chain. The related documentation and repeated verifications require considerable effort and have many chances for human errors. So, automating these processes has a great value. This article expounds a framework that harnesses block-chain and smart-contract technology to offer traceable and protected documentation of the assembly process. We expand the concept of a Bill-Of-Assembly (BOA) to incorporate data from the bill of materials (BOM), the associated assembly activities, the associated activities’ specification parameters and materials, and the associated assembly resources (machines and/or operators). The paper defines the operation of the BOA with blockchain and smart-contract technology, for attaining full traceability, safety, and security, for the entire assembled product. Future research could extend the proposed approach to facilitate the usage of the BOA data structure in constructing a digital twin of the entire simulated system.

Recent research has enabled the integration of traditional Volt-VAr Control (VVC) resources, such as capacitors banks and transformer tap changers, with Distributed Energy Resources (DERs), such as photo-voltaic sources and energy storage, in order to achieve various Volt-VAr Optimization (VVO) targets, such as Conservation Voltage Reduction (CVR), minimizing VAr flow at the transformer, minimizing grid losses, minimizing asset operations and more. When more than one target function can be optimized, the question of multi-objective optimization is raised. In this work, we propose a general formulation of the multi-objective Volt-VAr optimization problem. We consider the applicability of various multi-optimization techniques and discuss the operational interpretation of these solutions. We demonstrate the methods using simulation on a test feeder.

Carbamazepine (CBZ) is one of the most common emerging contaminants released to the aquatic environment through domestic and pharmaceutical wastewater. Due to its high persistence through conventional degradation treatments, is considered a typical indicator for anthropogenic activities. This study tested the removal of CBZ through two different clay-based purification techniques: adsorption of relatively large concentrations (20-500 μmol L-1) and photocatalysis of lower concentrations (<20 μmol L-1). The sorption mechanism was examined by FTIR measurements, exchangeable cations released, and colloidal charge of the adsorbing clay materials. Photocatalysis was performed in batch experiments under various conditions. Despite the neutral charge of carbamazepine, the highest adsorption was observed on negatively charged montmorillonite-based clays. Desorption tests indicate that adsorbed CBZ is not released by washing. The adsorption/desorption processes were confirmed by ATR-FTIR analysis of the clay-CBZ particles. A combination of synthetic montmorillonite or hectorite with low H2O2 concentrations under UVC irradiation exhibits efficient homo-heterogeneous photodegradation at μM CBZ levels. The two techniques presented in this study suggest solutions for both industrial and municipal wastewater, possibly enabling water reuse.

Silicon light funnels are three-dimensional subwavelength structures in the shape of inverted cones with respect to the incoming illumination. Light funnel arrays can serve as an efficient absorbing layers on account of their light trapping capabilities associated with the presence of high density complex Mie modes. Specifically, light funnel arrays exhibit broadband absorption enhancement of the of the solar spectrum. In the current study, we numerically explore the optical coupling between surface light funnel arrays and underlying substrates. We show that the absorption in LF array-substrate complex is higher than the absorption in LF arrays of the same height (~10% increase). This, we suggest, imply that a LF array serves as an efficient surface element that imparts additional momentum components to the impinging illumination, and hence optically excites the substrate by near-field light concentration, excitation of traveling guided modes in the substrate and mode hybridization.

We report on ground-based measurements of the atmospheric electric field (Ez= -Potential Gradient (PG)) and current density (Jz) that were conducted at two locations in Israel. One is the Emilio Segre cosmic ray station located on Mt. Hermon (34.45 N, 2020 m AMSL) located in northern Israel near the Syrian-Lebanon border and at the other at the Wise astronomical observatory in the Negev desert highland plateau of southern Israel (31.18 N, 870 m AMSL). We searched for possible effects of strong, short-term solar events on the potential gradient and the vertical current density, as disruption to the Global Electric Circuit are often observed following strong solar events. The first case study (St. Patrick Day, 17 March 2015) was classified as the strongest event of 2015. The second case study (8 Sep 2017) was categorized as the strongest event of 2017 and one of the twenty strongest events on record to date. The results show that the electrical parameters measured at ground level at both stations were not affected during the two massive proton events and the ensuing geomagnetic storms. The magnetospheric shielding in lower latitudes is strong enough to shield against flux of energetic particles from solar events, obscuring any impact that may be noticeable above the local daily variations induced by local meteorological conditions (aerosol concentrations, clouds, high humidity, and wind speed) which were investigated as well.

Disk galaxies have a typical dimension of few tens of thousands of light years. It follows from the theory of general relativity that any signal originating from the galactic center will be noticed at the outskirts of the galaxy only tens of thousands of years later. This retardation effect is absent in modelling used to calculate rotation curves throughout the entire galaxy and its external gas. The considerable differences between Newtonian action at a distance predictions and observed velocities are currently removed either by assuming dark matter or by suggesting various modifications to the laws of gravity, MOND being a long standing alternative to Newtonian gravity. In previous papers we have shown that applying general relativity in a rigorous fashion without mindlessly neglecting retardation, one can explain the radial velocities of galactic matter without modifying gravity or adding unseen matter. Moreover, it was shown that dark matter effects as they appear in gravitational lensing, the Tully-Fisher relation, and mass estimations based on the virial theorem could also be explained as retarded-gravity effects. In the original main paper on the subject only one galaxy (M33) was analysed in detail. This was later amended somewhat with a published study of eleven galaxies. Here we give a more comprehensive retardation analysis of 143 galaxies of different types from the SPARC Galaxy collection. We show that in most cases we obtain an excellent fit without postulating dark matter or modifying general relativity.

The Middle East spans the transition between temperate Mediterranean climate in the Levant to hyper-arid sub-tropical deserts in the southern part of the Arabian Peninsula, with the complex alpine topography in the northeast feeding the Euphrates and Tigris rivers which support life in the southeastern Fertile Crescent (FC). Climate projections predict severe drying in major parts much of the ME in response to global warming, making it important to understand the controls of hydro-climate perturbations in the region. Here we discuss 23 ME speleothem stable oxygen isotope (δ¹⁸Occ) records from 16 sites from the SISAL_v1 database, which provide a record of past hydro-climatic variability. Sub-millennial changes in ME speleothem δ¹⁸Occ values primarily indicate changes in past precipitation amounts superimposed on variations of the main synoptic pattern in the region, specifically Mediterranean cyclones. The coherency (or lack thereof) between regional records is reviewed from Pleistocene to present, covering the Last Glacial Maximum (LGM), prominent events during deglaciation, and transition into the Holocene. The available speleothem δ¹⁸Occ time-series are investigated by binning and normalizing at 25-year and 200-year time windows over the Holocene. Important Holocene climatic oscillations are discussed, such as the 8.2 ka, 4.2 ka and 0.7 ka (the Little Ice Age) Before Present events. Common trends in the standardized anomalies are tested against different climate archives. Finally, recommendations for future speleothem-based research in the region are given along with comments on the utility and completeness of the SISAL database.

Myocardial infarction (MI) remains the leading cause of death in the western world. Although medical advancements have been made in interventional revascularization technologies, a large percentage of patients are not candidates for them due to co-morbidities or lack of local resources. Thus, there remains a need for the development of novel non-invasive strategies to treat MI. Approaches to accelerate revascularization within ischemic tissues through angiogenesis by providing Vascular Endothelial Growth Factor (VEGF) in protein or gene form has been shown to be effective in animal models but not in humans likely due to its short half-life and systemic toxicity. We previously showed that a small peptide (PR1P) we developed stabilizes VEGF in its active dimer state, increases VEGF binding to its receptors and potentiates VEGF activity. Here we show that systemic PR1P treatment targeted, stabilized and upregulated endogenous VEGF within ischemic myocardium following left coronary artery surgery in mice and rats. Targeted VEGF upregulation led to augmentation of heart function at two weeks following surgery. We conclude that PR1P is a potential candidate therapeutic for MI.

The use of e-scooters and e-bicycles has been on the rise with an increased medical and financial burden. Our purpose was to identify risk factors for increased medical charges and recommend appropriate steps. We studied a retrospective cohort presenting to a level 1 urban trauma center from January 2018 through July 2019 due to micro-mobility platforms. The primary outcome for comparison was total billing cost and a regression analysis was performed to identify variables associated with higher cost. A total of 4073 patients were identified. The majority of which were males (67%), aged 20-30 years (41%). Helmet use reported in only 39.8%. Radiologic studies were performed more often in the e-bicycle group. Total billing charges amounted to 28.3 million New Israeli Shekels ($7.9 million). Average total cost was higher for e-bicycle injuries and in non-helmet users. Other factors associated with higher cost were age, and time of day 12:00-18:00. We recommend that urban cities invest in infrastructure in advance to micro-mobility introduction, regulate the use of e-platforms, designate resources for education on personal protective equipment and prepare medical centers in advance.