Under the main features required on portable devices in electrochemical instrumentation is to have a small size, low power consumption, economically affordable, and precision in the measurements. This paper describes the development of a programmable Embedded Potentiostat System (EPS) capable of performing electrochemical sensing over system-on-a-chip platforms. Furthermore, the study explains a circuit design and develops some validation of the entire system. The hardware validation is performed by electrochemical experiments such as Double Step Chronoamperometry (DSC), Linear Sweep Voltammetry (LSV) and Cyclic Voltammetry (CV); moreover, a comparison of the experimental signals between a commercial potentiostat and the EPS was done by analysis of errors on the response signal. Results illustrate that the EPS is capable of handling currents in the range of absolute values of 86.44 to 3000 nA, and having control voltages in the range of ± 2 V. The device can support from 50 to 2000 samples per second. The EPS capabilities were compared with other compact potentiostats. The programmable EPS is an original approach which hugely reduces the hardware complexity and leads the way to create new applications for Point-of-Care or industrial developments with a reusable full electronics module.

Malnutrition problems are related to diets that lack one or more essential elements, which it is extremely important to food enrichment to improve the content of compounds effective for health. The objective of this study is to evaluate the effect of the addition of Ca2+, K+ and Mg2+ on the induction of nutraceutical quality in grafted tomatoes grown in the NFT (Nutrient Film Technique) system. In the experiment, two factors were evaluated: plants with and without grafting and the foliar application of 10 ml L−1 Ca2+, 4 ml L−1 K+ and 10 ml L−1 Mg2+ cations separately for each case, in addition to the control. The treatments were evaluated using a completely randomized design, with 5 repetitions per treatment. The interactive effects between grafting and foliar application of Ca2+ induced a greater content lycopene, β-carotene and total flavonoids in fruits of tomato. The interactive effects between the graft and the Mg2+ foliar applications obtained the best results in the phenol content. As regards, capacity DPPH and ABTS, the graft decreased concentration, increasing the content of these through foliar applications of calcium. Regarding the enzymatic variables, graft factor increased activity catalase, glutathione peroxidase and phenylalanine ammonium lyase, obtained the best results graft interaction and foliar application of calcium and magnesium. The results obtained demonstrate the influence of the use of grafts and foliar applications of cal-cium and magnesium as tools that could improve the nutraceutical quality content of tomato crop

Right atrial isomerism (RAI) is a complex entity whose treatment and outcome are heterogeneous. The aim of this study was to analyze the results obtained after cardiac surgery in patients with RAI. A retrospective study was conducted; it included patients diagnosed with RAI who underwent cardiac surgery; their follow-up was from January 1, 2010 to March 31, 2020. Demographic characteristics and perioperative conditions were described. Thirty-eight patients with RAI were included, the median age was 4 years (IQR 2-9.2), and 57.9% were men. The main diagnoses were atrioventricular canal (63.2%) and pulmonary stenosis (55.3%). The most common surgical procedures were modified Blalock‐Taussig shunt (65.8%) and total cavopulmonary connection with an extracardiac conduit fenestrated without cardiopulmonary bypass (15.9%). The use of inhaled nitric oxide was a marker of postoperative mortality in critically ill patients (OR: 10.33; 95% CI: 1.04 - 102.08; p = 0.02). The overall survival was 86.8%, with a better outcome in those who did not require reintubation (Log Rank, p < 0.01). The survival of RAI was similar to other centers of reference. Individuals with RAI should be evaluated rigorously to determine an adequate repair strategy, considering high morbidity and mortality.

3D bioprinting, like 3D printing, is a process that builds structures by depositing material layer by layer. In the specific case of bioprinting, these layers are composed of a biocompatible material together with living cells, allowing the creation of three-dimensional structures that recreate functional tissues and organs. Bioprinting cell-laden structures is complicated by the high rate of cell damage and stress that occurs during the process, caused by the high pressures and stresses to which they are subjected. To minimise damage during the process, it is important to study and optimise certain bioprinting conditions beforehand and to analyse how they affect the cells by means of computational simulations. In this review, both quantitative and qualitative data are collected to improve the nozzle geometry through computational simulation studies. Optimal ranges for nozzle diameter (0.2-1mm) and length (8-10mm; 300-900μm) have been defined, and recommendations for improving nozzle performance during bioprinting, such as the provision of an inner angle of 20-30°, an inner EDTA coating and a shear stress of less than 10kPa, have been gathered. Finally, based on the data collected, a design of experiments is proposed to obtain an optimal bioprinting configuration for a particular bioink.

Acute ischemic stroke (AIS) is the loss of neurological function due to a sudden reduction in cerebral blood flow and is a leading cause of disability and death worldwide. In recent years, the field of radiological imaging has experienced an explosion that may reach unprecedented heights with the advent of artificial intelligence. One of the latest innovations in artificial intelligence is radiomics, which is based on the fact that a large amount of quantitative data can be extracted from radiological images, from which patterns can be identified and associated with specific pathologies. Since its inception, radiomics has been particularly associated with the field of oncology, with promising results in a wide range of clinical situations. The performance of radiomics in non-tumour pathologies has been increasingly explored in recent years and the results continue to be promising. The aim of this review is to explore the potential applications of radiomics in AIS patients and to theorise how radiomics may change the paradigm for these patients in the coming years.

Shoulder tendinopathies produce pain and reduce functionality. The aim of this randomized clinical trial was to analyze the effects of Percutaneous electrolysis (PE), Percutaneous peripheral Nerve Stimulation (PNS) and eccentric exercise (EE), on pain (NPRS), strength, electromyographic activity, ultrasound characteristics of the tendon (echogenicity, thickness and hypervascularization) and functionality (DASH and SPADI) on individuals with supraspinatus tendinopathy. Participants (n=50) were divided into two groups, they received 4 treatment sessions, one per week, of PE and PNS (n=25) or 10 treatment sessions of TENS and US (n=25). Both groups performed EE program consisted of 3 sets of 10 repetitions of each of the 3 exercises, twice a day, during the 4 weeks. Follow-up was carried out at 4, 12 and 24 weeks after the start of the intervention. There are statistically significant differences in the analysis between groups (p&lt;0.001) in the post-treatment and follow-up measurements favorable to the PE+PNS+EE treatment on pain (NPRS), strength, supraspinatus electromyographic amplitude, ultrasound characteristics of the tendon (echogenicity, thickness and hypervascularization) and DASH and SPADI questionnaires. The combined treatment PE, PNS and EE is an effective option in the clinical management of tendinopathies, with positive results in the short and long term on the variables studied.