Abstract Psychiatric care in Spain has experienced relevant changes both in the legislative and conceptual frameworks. This new approach advocates for the combination of carrying out mental health promotion, prevention of alterations and early diagnosis and treatment, enhancing actions against stigma and emphasising the attention on the most vulnerable groups, like childhood and youth. For that, it has seen fit to perform a nursing intervention on Education and Promotion of mental health for teachers and counsellors of a secondary school located in Valencia, with the general objective of assessing their impact on stigma. Non-randomised clinical trial in which a nursing intervention on Education and Promotion of mental health was performed. Pre-intervention tools: multiple choice test validated by a group of experts; pre and post-intervention: AQ-27 (stigma attribution); in order to check its acceptance, satisfaction surveys were used. The inferential analysis included the Wilcoxon Test (pre and post AQ-27) and the Pearson Correlation Test for the quantitative variables of interest. Sample (n=22): women aged 47.96 ± 10.12 years with 18.64 ± 10.34 years of work experience. The predominant stigmatising attitude before and after intervention was “Coercion”. The ones with lower score were “Segregation” and “Anger”. The p-values obtained in the Wilcoxon Test were statistically significant (p-value <0.05) except for “pre and post Responsibility” and “pre and post Pity”. The following constructs of interest were faced: “Age” vs “Fear” (r= -0.48, moderate), “Professional experience” and “Fear” (r= -0.46, moderate) and “Help” and “Psychosis test” (r= 0.51, severe). The overall satisfaction score was 9/10. Despite the scores obtained in “Coercion” and “Psychosis”, the intervention was useful for reducing stigma in the sample.

A new layout optimization method for offshore wind farms is proposed to minimize power deficits due to wake effect. The main engine of the algorithm is a gradient-descent method, in which an analogy is established between power deficit and repulsive electrostatic potential energy. To achieve a maximum dispersion in the initial solution, throughout the optimization process, new turbines are included in the centre of the concession area, and quickly expand outward looking for areas with less potential, in turn pushing the previous ones. When the optimization process ends, to avoid local maximums, it enters into a process of suppression of the set of locations that cause the greatest potential (power deficit). Then, a potential map of the entire area is created and a greedy algorithm includes new turbines to complete the layout with the final number of turbines. To speed up the search process and the creation of the potential map, two simplifications have been validated and added: the spatial distribution of velocities has been converted into its equivalent with point symmetry; and, for turbines affected by multiple wakes, the power deficit has been calculated by using a linear aggregation of powers, instead of the usual linear (or quadratic) aggregation of speeds. Owing to this type of aggregation, the process is accelerated in a factor of 90.

Migratory and local birds may disperse ticks and their associated pathogens. The aim of this study was to provide information regarding tick infesting birds in Asturias, region that accounts for most of the Lyme disease hospitalizations in Spain. From September 2021 and April 2023 trained and experienced bird- banders collected ticks from birds in six estuary and forest locations. A total of 1,698 birds (52 species, 38 genera and 26 families) were captured. A total 51 ticks (28 larvae, 20 nymphs and 3 females) were collected from 43 birds, belonging to three species: Ixodes ricinus (31), I. frontalis (18) and Haemaphysalis concinna (1). The average prevalence of tick infestation was 2.5% and the average tick burden was 1.2 ticks per host. The bird species Turdus merula, Parus major, Luscinia svecica and Anthus pratensis were among the most infested. Anaplasma phagocytophilum was detected from one Turdus merula. We have not detected B. burgdorferi s.l., Rickettsia spp., Coxiella burnetii or piroplasmids in any of the 51 analyzed ticks. The results of the study suggest low infestation rate in migratory/estuary birds and a higher rate in forest/sedentary ones. Despite this, the detection of pathogens, although with low prevalence, can pose a risk to public health.

Objectives: To assess the short-term impact of a single global stretching session on plantar pressures and lumbar range of motion (RoM) over one week in sedentary university students. Design: A randomised controlled trial with two parallel groups. Participants: Sixty-four university students were randomly assigned to a stretching group or control group. The stretching group received a single session of global stretching and the control group remained seated for the same length of time as the stretching session. Main outcome measures: Lumbar RoM and plantar pressures were assessed before, immediately after, 48 hours after, and 7 days after intervention. Results: Group-by-time interaction was significant for lumbar lateral flexion (p = 0.044), right maximal pressure (p = 0.003), left maximal pressure (p = 0.008), right mean pressure (p = 0.025), left mean pressure (p = 0.002), and maximal pressure minus mean pressure in right foot (p = 0.007). The model with plantar pressures showed a significant difference for group-by-time interaction (p = 0.010).Conclusion: Global stretching seems to counteract the ill-effects of prolonged sitting up to seven days with respect to plantar pressure in standing without improving lumbar ROM

Currently, the textile industry is a poorly automated sector, due in part to problems in the handling of deformable leather and textile parts during production operations. In this work, several problems in the handling process of leather and textile parts are addressed, introducing methods to increase the automation of the process. A pneumatic actuator designed to pick up textile or leather parts avoiding their deformation during transport has been developed. This actuator maximizes the number of gripping points to improve handling, making it more stable and efficient. Additionally, a vision system has been implemented in the part picking task which, in conjunction with the CAD information of the part, sends the modified gripping position of the part to the robot. This allows customized handling of each textile or leather part. Finally, validation tests have been carried out on this development, both in simulations and in laboratory conditions, demonstrating its viability and direct applicability in the production line.