Computer simulation relies on well-defined experimental supported theories, models, and numerical methods. Computer simulation is an alternative to fill the gaps where the experiment is pricy or limited in engineering. Computer simulation is a high-fidelity computational technique that can work as an engineering innovation tool to try imaginative ideas beyond the available technologies. The accuracy of current computer simulation results is reliable enough to accelerate innovation for new materials and mechanical technologies without experimental validation. So, we may need to urge relying on computer simulation results without any experimental validation to accelerate engineering innovations. In addition, using high-fidelity computer simulation for engineering innovation acceleration without validation will be promoted if it is credited as a new classification. This subject and a related justification's classification in engineering have been discussed.

We discuss the influence played by different statistical models in the prediction of porosity and litho-fluid facies from logged and post-stack inverted acoustic impedance (Ip) values. We compare the inversion and classification results obtained under three different a-priori statistical assumptions: an analytical Gaussian distribution, an analytical Gaussian-mixture model and a non-parametric mixture distribution. The first model assumes Gaussian distributed porosity and Ip values, thus neglecting their facies-dependent behaviour caused by different lithologic and saturation conditions. Differently, the other two statistical models relate each component of the mixture to a specific litho-fluid facies, so that the facies-dependency of porosity and Ip values is taken into account. Blind well tests are used to validate the final predictions, whereas the analysis of the maximum-a-posteriori (MAP) solutions, the coverage ratio and the contingency analysis tools are used to quantitatively compare the inversion outcomes. This work points out that the correct choice of the statistical petrophysical model could be crucial in reservoir characterization studies. Indeed, for the investigated zone it turns out that the simple Gaussian model constitutes an oversimplified assumption, while the two mixture models provide more accurate results, although the non-parametric one yields slightly superior predictions with respect to the Gaussian-mixture assumption.

Terahertz tomography is a promising method among non-destructive inspection techniques to detect faults and defects in dielectric samples. Image quality recently significantly improved through the incorporation of a priori information and off-axis data. However, this improvement has come at the cost of increased measurement time. To aim toward industrial applications, it is therefore necessary to speed up the measurement by parallelizing the data acquisition employing multi-channel setups. In this work, we present two tomographic frequency-modulated continuous wave (FMCW) systems working at a bandwidth of 230-320 GHz, equipped with an eight-channel detector array, and compare their imaging results with a single-pixel setup. While in the first system, the additional channels are used exclusively to detect radiation refracted by the sample, the second system features an f-θ lens, focusing the beam at different positions on its flat focal plane, and thus utilizing the whole detector array directly. The usage of the f-θ lens in combination with a scanning mirror eliminates the necessity of the formerly used slow translation of a single-pixel transmitter. This opens up the potential for a significant increase in acquisition speed, in our case by a factor of four to five, respectively.

Public health suffers from noxious gas of beached Sargassum algae. Floating barrages containing them at sea will be useful provided efficiently catch them and resist to hydrodynamic pressure. Nowadays design and installation of algae barrages are empiric. Structural break, anchor and mooring chain drifts can arise. We provide a mechanical model to evaluate stresses and loads on a structure made of nets and moorings. Hydrodynamic uncertainties occur through catches, fouling, and a range of sea currents appearing in lagoons or sheltered bays. We consider a nonlinear finite-element model of elastic membrane in large displacements and small strains. We study some forcings fixed a priori on a standard section of barrage. A section 50 m long, 1 m high, with two net-faces is examined at low and moderate current velocities, 0.05 and 0.35 m.s-1, while assuming specific vertical and horizontal catch pressures. A barrage installed in lagoon at Le François on Martinique Island and being observable by satellite imagery could benefit of the computed net and mooring tensions.