A critical discussion on the computation of the dispersion diagram in periodic one-dimensional guiding structures is carried out. In particular, an analysis is presented of the pros and cons of combined methods that make use of full-wave simulations done with commercial software packages with further analytical post-processing based on simplifications brought by an equivalent circuit model of the structure. Some of the most common methods reported in the literature are reviewed and their advantanges and limitations highlighted. Our discussion is complemented with several selected numerical examples in order to discuss the most relevant aspects that a potential user of these methods should be aware of. Special attention is paid to the relevant role played by the high-order coupling between the two halves of a symmetric unit cell of the periodic structure.

The trigeminal nerve is responsible for innervating the periorbita. Ultrasound-guided trigeminal block is employed in humans for trigeminal neuralgia or periorbital surgery. There are no studies evaluating this block in dogs. This study aims to evaluate and compare two approaches (coronoid and temporal) of the trigeminal nerve block. We hypothesized superior staining with the coronoid approach. Thirteen dog heads were used. After a preliminary anatomical study, two ultrasound-guided injections per head (right and left, coronoid and temporal approach, randomly assigned), with an injectate volume of 0.15 mL cm-1 of cranial length were performed (iodate contrast and tissue dye mixture). The ultrasound probe was placed over the temporal region, visualizing the pterygopalatine fossa. For the temporal approach, the needle was advanced from the medial aspect of the temporal region in a dorsoventral direction. For the coronoid approach, it was advanced ventral to the zygomatic arch in a lateromedial direction. CT scans and dissections were conducted to assess and compare the position of the needle, spread of injectate, and nerve staining. No significant differences were found. Both approaches demonstrated effective interfascial distribution of injectate, with some minimal intracranial spread. Although the coronoid approach did not yield superior staining as hypothesized, it presents a viable alternative to the temporal approach. Studies in live animals are warranted to evaluate clinical efficacy and safety.

This research program investigated the effects of layer thickness (50 and 100 microns) on the microstructure and mechanical properties of electron beam powder bed fusion (EBPBF) additive manufacturing of Inconel 625 alloy. The as-built 50 and 100 micron layer thickness components were also heat treated at temperatures above 1100 oC, which produced a recrystallized grain structure containing annealing twins in the 50 micron layer thickness components, and a duplex grain structure consisting of islands of very small equiaxed grains dispersed in a recrystallized, large-grain structure containing annealing twins. The heat treated component microstructures and mechanical properties were compared with the as-built components in both the build direction (vertical) and perpendicular (horizontal) to the build direction. Vickers microindentation hardness (HV) values for the vertical and horizontal geometries averaged 227 and 220 for the as-built 50 and 100 micron layer components, and 185 and 282 for the corresponding heat treated components. The yield stress values were 387 MPa and 365 MPa for the as-built layer horizontal and vertical 50 micron layer geometries, and 330 MPa and 340 MPa for the as-built 100 micron layer components. For the heat treated 50 micron components, the yield stress values were 340 and 321 MPa for the horizontal and vertical geometries, and 581 and 489 MPa for the 100 micron layer components, respectively. The elongation for the 100 micron layer as-built horizontal components was 28% in contrast to 65% for the corresponding 100 micron heat treated layer components, an increase of 132% for the duplex grain structure. However, the coarse grains containing annealing twins and the equiaxed small grain islands in the duplex structure for the heat treated components contained continuous carbides in the grain boundaries, and this may indicate sensitization and a reduction in corrosion resistance. These findings point to the potential mechanical property advantage for heat treatment of Inconel 625 alloy 100 micron layer thickness components fabricated by EBPBF.