The study investigates the effects of immobilizing the fungi on the straw's performance as an oil sorbent. The buoyancy of the straw with fungi was found to be unaffected by the immobilization process. Even when sorbed with oil, the straw floated on the water’s surface throughout the 14-day test period. The sorption kinetics of the oil appeared similar in straw with and without immobilized fungi, regardless of beaker shaking. However, the fraction of non-extractable oil was higher in the straw with fungi and shaking compared to the straw without shaking. This observation suggests the potential initiation of oil mining. Based on these results, it is suggested that instead of leaving the straw with fungi and oil in the water, removing it may be beneficial and allow for oil degradation and straw decomposition on land.

With the development of health service, animal husbandry, aquaculture and chemical industry, more and more pollutants are discharged into the water environment, including antibiotics and heavy metal ions. These hazard substances pose a great threat to environment safety and human health. As two kinds of new green solvents, ionic liquids (ILs) and deep eutectic solvents (DESs) are widely used in various fields including separation and environmental engineering, which are attracting huge attention from academia and industry. In this study, the optimal ionic liquid and deep eutectic solvent were selected and their complex with β-cyclodextrin (β-CD) were firstly prepared by simple and effective inclusion way. After necessary characterization and analysis, two kinds of complex were applied to prepare a special sorbent disc with two different sides by adding diluent (excipient) and pressing under 5~15 MPa. As the result, the IL and DES could be stably immobilized on the disc and play the key role in selective adsorption for targets. Besides that, the experiments of different hazardous substances achieved the expected results. Based on this study, the complex disc showed a lot of merits in the separation performance, easy preparation and use, simple operation, and good stability. It was believed to be a useful tool for water purification and detection.

Water recycling and reuse are corner stones in the water management that may be compromised by the presence of pollutants. Among them, pharmaceuticals can overcome the standard water treatments and require sophisticated approaches to remove them. Sorption is an economically affordable alternative limited by the need of sorbents that exhibit sorption coefficient (Kd) higher than 500 L/kg to be useful in wastewater treatment plants (WWTPs). We report that th cross-linking of dextrin (Dx) with divinyl sulfone (DVS) in presence of 1 mmol or 5 mmol of ibuprofen (IBU) yields the insoluble polymers pDx1 and pDx5 with improved affinity for IBU, Kd higher than 600 L/kg for ciprofloxacin (CIP) and ofloxacin and an outstanding Kd higher than 4000 L/kg for erythromycin (ERY), when assayed against a cocktail of 6 drugs. The characterization of the polymers by XRPD, TGA and SEM reveals that both pDx1 and pDx5 share similar features, with an ERY Kd of 13 x 103 for pDx1 and 6.4 x 103 for pDx5. The facts that new affinities and improvements in Kd can be achieved by cross-linking Dx in presence of other molecules that promote a pre-organization, broaden the applications of DVS cross-linked polysaccharide as sustainable and eco-friendly sorbents.

A comparative study of the physicochemical properties of natural bentonite clays of Pogodayevо (Republic of Kazakhstan, mod.1) and Dash-Salakhli (Republic of Azerbaijan, mod.2) deposits and modification of the bentonite clay with polyhydroxocations of iron (III) and aluminium (III). It-wasestablished that the modification of natural bentonitesusing polyhydroxocations of iron (III) and aluminium(III) by the method of "co-precipitation" leads to a change in their chemical composition, structural and sorption properties. The results showed that hydroxy-aluminum cations ([Al3O4(OH)24(H2O)12]7+) and poly-hydroxyl-Fe or polyoxo-Fe were intercalated into clay layers, which led to an increase in the values of d001 and specific surface areas compared to those of the original bentonite, from 37 to 120 for the Pogodaevo bentonite and from 51 to 172 respectively for bentonite from the Dash-Salakhli deposit. It is shown that modified sorbents based on natural bentonite are finely porous objects with a predominance of pores of 1.5−6.0 nm in size. As a result, there is a significant increase in the specific surface area of sorbents. Modification of bentonite with polyhydroxocations of iron (III) and aluminium (III) by the "co-precipitation" method also leads to an increase in the sorption capacity of the sorbents obtained with respect to nickel (II) cations. Modified bentonites were used for the adsorption of Ni (II) ions from the model solution. Ni (II) was absorbed in a neutral pH solution. The study of equilibrium adsorption showed that the data are in good agreement with the Langmuir isotherm model. The maximum adsorption capacity of the Ni (II) monolayer obtained from the Langmuir equation was 25.0 mg/g (mod. 1_Al_5-c), 18.2 mg/g (mod. 2_Al_5-c) for Al-bentonite and 16.7 mg/g (mod. 1_Fe_5-c), 10.1 (mod. 2_Fe_5-c) for Fe-bentonite. The kinetics of adsorption is considered. The high content of Al-OH anion exchange centresin them determines the higher sorption activity of Al-modified bentonites.

Improving the quality of natural water purification is one of the priority areas in the research of scientific communities in the field of ecology. At the same time, the task is to achieve optimal efficiency at a low cost of the technological process. The solution in this case is the use of materials necessary for cleaning, in particular, sorbents from natural raw materials, including agricultural waste. At present, a sufficient number of research results have been published confirming the effectiveness of the sorbent from biochar of various agricultural wastes, as well as from rice straw biochar. This article proposes an innovative method for modifying biochar from rice straw, which allows the use of the material as a sorbent with a disinfecting effect. The method consists in processing biochar in a process activation apparatus (PAP) in a solution of silver nitrate with the release in the form of a carbon nanomaterial with attached metallic silver ions on the surface of biochar particles. Rice straw biochar was mixed in distilled water with silver nitrate AgNO3 and placed in the AAP in a replaceable insert with ferromagnetic particles that have a magnetostrictive effect under the influence of an electromagnetic field. Next, the contact of biochar impregnated with a solution of silver nitrate and ferromagnetic particles was carried out for 2 minutes under electromagnetic influence, after which the treated sample was dried in an oven for 4 hours at t=105ºС, followed by calcination in a muffle furnace at 450ºС for 3 hours. The resulting silver-containing sorbent was subjected to a physicochemical analysis of its properties, photographs of electron microscopy were also obtained, and a bacteriological analysis of the effectiveness of the sorbent on natural water was carried out. According to the results of the analyzes, the silver-containing sorbent is a mesoporous nanomaterial with an average mesopore diameter for desorption of 196 Å, a relative volume of pores with a diameter of up to 900 Å 0.034 cm³/g,, specific surface 7.45 m²/g and a content of metallic silver ions on the surface of the sorbent particles of (Ag) 16.7%, oxygen (O) 54.9%, unexpectedly (С) 13.7%, silicon (Si) 8.1%. Laboratory studies for the bacteriological analysis of natural water consisted in the sorption processing of the selected samples in the carbonization mode, followed by sedimentation after the introduction of the reagent (a mixture of coagulant and flocculant). The analysis was carried out on three indicators - total microbial count (TMC), total coliform bacteria (TCB) and thermotolerant coliform bacteria (TCB). According to the research results, the sorbent showed its disinfecting properties and confirmed its high efficiency (90,48%-100%).

The possibility of deep radiochemical purification of Li2CO3 has been examined in the frame of the purification program of AMoRE collaboration. In this experiment, commercial Li2CO3 was converted into LiNO3. Co-precipitation with inorganic salt-based carriers followed by membrane filtration and sorption using MDM inorganic sorbent methods were tested for the removal of alkaline-earth and transition metals, potassium, magnesium, aluminum, uranium, thorium, and radium. The calcium molybdate-based carrier was the most efficient for removing Th, U, and K. Subsequently, the radium, calcium, and barium contaminations were removed with MDM sorbent. After the impurities’ removal, the final Li2CO3 product was synthesized with NH4HCO3 sludge. The separation factors were derived by means of ICP-MS and HPGe analyses of the initial material, intermediate and final products. The study showed the optimum conditions of co-precipitation and sorption to reach a high yield and radiopurity of lithium carbonate used for low radioactive background experiments.