The paper investigates the performance of a full analog self-jammer canceller able to operate in UHF RFID devices. The scheme has been realized using only SMT devices avoiding custom designed components. The paper analyzes the theoretical performance and experimental validation using a modular microwave technology approach.

Regular weight measurement is important in fattening geese to assess their health status. Failure to gain weight may indicate a potential illness. Standard weight gain analysis involves direct contact with the animal, which can cause stress to the animal, resulting in overall negative impacts on animal welfare. The focus of this study was to design a smart solution for monitoring weight changes in the breeding of farm animals. The proposed IoT system with a weighing device equipped with RFID technology for animal registration aimed to minimise the negative aspects associated with measuring in contact with humans. The designed system aims to incorporate modern approaches in animal husbandry and utilise the acquired data for the potential development of breeding approaches for various animal breeds. The system consisted of three main components: a data acquisition system, a weighing system with RFID, and an environmental monitoring system. In this study, the RFID system accuracy for detecting geese in the weighing system environment was assessed. The entire system evaluation yielded a sensitivity of 93.87%, specificity of 99.94%, accuracy of 99.85%, and precision of 95.09%. Regression analysis revealed a good correlation between observed feeding and RFID registrations with a determination coefficient of R2 = 0.9813.

In this paper, we considered two phenomena in acoustically excited aqueous solutions of a strong electrolyte. These are the well-known Debye ionic vibrational potential (IVP), and radiofrequency anisotropy we discovered earlier , apparently, for the first time. Since both occur due to the accelerated motion of the solution, we have tried to combine them in one simple model. We have established that for a polarized UHF radio wave passed through a NaCl aqueous solution excited by an acoustic pulse the rotation angle of its vector E is proportional to the integral of the square of the observing IVP over time. An equivalent electrical circuit simulating the observed phenomena has been proposed and tested for physical feasibility. Several arguments are given in favour of the fluid-gyroscopic mechanism of RF anisotropy-related effects. We also found out that the IVP is practically independent of the vibrational velocity for frequencies below 10 kHz and it tends to zero at zero frequency. The latter is consistent with the law of conservation of energy but contradicts the incomplete existing theory.

The most common source of transformer failure is in the insulation, and the most prevalent warning signal for insulation weakness is partial discharge (PD). Locating positons of these partial discharges would help repair the transformer to prevent failures. This work investigates algorithms that could be deployed to locate the position of a PD event using data from ultra-high frequency (UHF) sensors inside the transformer. These algorithms typically proceed in two steps: first determine the signal arrival time and then locate the position based on time differences. This paper reviews available methods for each task and then propose new algorithms: a convolutional iterative filter with thresholding (CIFT) to determine the signal arrival time and a reference table of travel times to resolve the source location. The effectiveness of these algorithms are tested with a set of laboratory-triggered PD events and two sets of simulated PD events inside transfers in production use. Tests show the new approach provides more accurate locations than the best-known data analysis algorithms, and the difference is particularly large, 3.7X, when the signal sources are far from sensors.