This research intended to report amine-functionalized multiwall carbon nanotubes (MWCNTs) prepared by a simple method for efficient and rapid removal of Reactive Yellow 2 (RY2) from water. EDS analysis showed that the N content increased from 0 to 2.42% and from 2.42 to 8.66% after modification by APTES and PEI, respectively. BET analysis displayed that the specific surface area, average pore size, and total pore volume were reduced from 405.22 to 176.16 m2/g, 39.67 to 6.30 nm, and 4.02 to 0.28 cm3/g, respectively. These results proved that the PEI/APTES-MWCNTs were successfully prepared. pH edge experiment indicated that pH 2 was optimal for RY2 removal. At pH 2 and 25 °C, the time required for adsorption equilibrium was 10, 15, and 180 min at initial concentrations of 50, 100, and 200 mg/L, respectively; and the maximum RY2 uptake calculated by the Langmuir model was 714.29 mg/g. Thermodynamic studies revealed that the adsorption process was spontaneous and endothermic. 0-0.1 mol/L of NaCl showed negligible effect on RY2 removal by PEI/APTES-MWCNTs. Five adsorption/desorption cycles confirmed the good reusability of PEI/APTES-MWCNTs in RY2 removal. Overall, the PEI/APTES-MWCNTs are a potential and efficient adsorbent for reactive dye wastewater treatment.

This study reports the recovery of Pd(II) from acid solution by a polyethylenimine (PEI) crosslinked chitin (PEI-chitin) biosorbent. FE-SEM analysis demonstrated that there are many slot-like pores on PEI-chitin. N2 adsorption-desorption experiment revealed that the average pore size was 47.12 nm. Elemental analysis verified the successful crosslinking of PEI with raw chitin. The Langmuir model better explained the isotherm experimental data and the theoretical maximum Pd(II) uptake was 59.6 mg/g. The adsorption kinetic data was better described by pseudo-second-order model and the adsorption equilibrium was achieved within 30 min for all initial Pd(II) concentrations of 50-200 mg/L. In the fixed-bed column, the adsorption of Pd(II) on PEI-chitin showed slow breakthrough and fast saturation performance. The desorption experiments achieved a concentration factor of 8.4 ± 0.4. In addition, adsorption-desorption cycles in the fixed-bed column were performed up to 3 times, consequently confirming the good reusability of PEI-chitin for Pd(II) recovery. Therefore, the PEI-chitin can be used as a promising biosorbent for the recovery of Pd(II) in practical applications.