A robust methodology to simulate virtually the residual stresses pattern in welded steel plates is presented. The methodology is applied to the structural analysis of typical welded plates belonging to ship structures, and the effect of residual stresses on the elastoplastic behavior of plates loaded axially is analyzed in comparison to the residual stress free case, both for tension and compression and including initial imperfections. Residual stresses affect in different manner plates with different geometries; thus a parametric study is performed covering the usual range of variation of the most important plate parameters that control the strength of the plates, more precisely the slenderness and the aspect ratio. The results from finite elements analysis are compared with codes and most stablished formulations and recommendations of applicability in the prediction of load-shortening curves for hull’s bending strength evaluation, ultimate strength and ultimate strain of plate elements are made.

Welded structures are subjected to internal residual stress after manufacturing that may affect the structural strength and normally are associated with an increase on initial geometrical imperfections. This study presents a simplified method to generate an adequate representation of residual stresses on Finite Element models for structural analysis of thin-walled structures and other applications. The results obtained shown that the methodology proposed to introduce residual stresses is simple, accurate and efficient on the modulation of post-welding stresses and their pattern, thus it may be used for simulation of the thermal process.

The present work studies the concept of productivity in shipbuilding and how it should be measured. The existing metrics, shipbuilding process and shipyard organization were studies in order to choose the most adequate metrics which would allow the measuring of a shipyard productivity in a systematic and holistic way. This is achieved by gathering the man-hours spent in each ship organized by cost centre and using Compensated Gross Tonnages as the measure of output from the shipyard. Data was gathered for thirty ships built in the same European yard organized by cost centre. From the data collected it was found that the ratio of hours spent in outfitting to the hours spent in structures is proportional to the complexity of the ship. There was also opportunity to study the work reduction resulting from building ships in series and the shares of labour for ships series and across ship types.