The phonon modes in YBa₂Cu₃O_7-δ and YBa_2-xLa_xCu₃O_7-δ systems have been systematically studied by Raman spectroscopy. The new phonon modes of 104 cm^-1, 94 cm^-1, and 89 cm^-1 were found in all these samples. A crude estimate about the wavenumber of the collective vibration of the stable CuO2 plane was given in this paper. The standard deviations of the new phonons in YBa₂Cu₃O_7-δ and YBa_2-xLa_xCu₃O_7-δ systems were discussed. The results of the calculation indicated that the 104 cm^-1 mode probably stands the c-direction collective vibration of the stable CuO2 plane, the 94 cm^-1 mode stands the a-direction vibration, and the 89 cm^-1 mode stands b-direction vibration. The relevance between these phonons and the superconductivity was discussed. It is found that, as the T_c decreased, the 104 cm^-1 mode and the 94 cm^-1 mode softened, and the 89 cm^-1 mode hardened slightly.

This study aims to investigate the hydration and strength characteristics of green cementitious mortars with ultrahigh-volume limestone-calcined clay as well as two kinds of Class F fly ash. Using the ASTM C311 strength activity index test method, the effect of different pozzolan replacement levels of cement (0%, 20%, 50%, and 80%, by weight) were investigated. Compressive strength at 3, 7, 14, 28 and 90 days under standard curing was recorded, and hydration heat of the 20% and 80% replacement mixes was studied using iso-thermal calorimetry. It was observed that the effectiveness of the pozzolan in mortars depends on particle size distribution, glassy or amorphous nature, surface area and replacement level. The sum of all these effects can be captured by the strength activity test only if the standard recommended 20% pozzolan mix is substituted with the actual mix composition. The results in this study provide insights into the mix design and applications of ultrahigh-volume pozzolanic cementitious materials specifically made with limestone-calcined clay, and promote greener cement and concrete in construction industry.

Objective: To explore the efficacy and safety of breathing exercises for pain management in cancer survivors. Design: A systematic review. Data sources: Thirteen databases, including PubMed, EMBase, CENTRAL, Medline, CINAHL, JBI, Science Direct, Scopus, SocINDEX, Web of Science, PsycINFO, CNKI, and Wan Fang, were searched from inception to May 24, 2021. Review/analysis methods: Studies that focused on the efficacy of breathing exercises for pain management in cancer survivors were included. Cochrane tools were used for the quality appraisal of the included studies. Due to the heterogeneity of the studies, descriptive data analysis was used to summarize the results. Results: A total of 10 studies were included in this systematic review. Slow pursed lip breathing showed benefits for post-surgical pain. Contradictory findings were identified in the Enhanced Recovery After Surgery breathing exercise for post-surgical pain. Slow deep breathing and Hey-Hu regular breathing techniques were effective for pain management in pediatric cancer patients. The Active Cycle of Breathing Technique and five-minute mindful breathing did not have any statistically significant effects on pain relief. Quality of life was measured in three studies, with some improvement. Only one study addressed adverse events and reported that no adverse events associated with the breathing exercises occurred during the study. Conclusion: This review found some evidence of positive effects of breathing exercises for pain relief in cancer survivors. However, the unsatisfactory methodological quality of the studies prevents its generalizability. More large-scale studies are needed to assess the efficacy and safety of breathing exercises for pain relief in cancer survivors.

Under the increasingly severe global heat threat, continuous high temperature has far-reaching effects on plant growth and development and become a major constraint to crop production. The development of heat-resistant varieties has become research hotspot in many fields, and it is also necessary to establish effective identification methods. In this study, twenty Brassica rapa varieties were selected to to investigate the physiological and biochemical characteristics under heat stress, explore the relationship between physiological response and the heat resistance mechanism, select some typical heat-resistant and heat-sensitive varieties. The effects of photosynthetic electron transfer and antioxidant pathway on heat resistance of Brassica rapa were identified. These findings will providing an important reference for the physiological regulation and identification method of high-temperature stress in plants.

Background: A growing number of clinical practice guidelines (CPGs) with regards to non-pharmacological interventions for breast cancer survivors are available. However, given the limitations in guideline development methodologies and inconsistency of recommendations, it remains uncertain how best to design and implement such non-pharmacological strategies to tailor interventions for breast cancer survivors with varied health conditions, healthcare needs, and preferences. Aim: To critically appraise and summarise available non-pharmacological interventions for symptom management and health promotion that can be self-managed by breast cancer survivors based on the recommendations of the CPGs. Methods: Clinical practice guidelines which were published between January 2016 and September 2021 and described non-pharmacological interventions for breast cancer survivors were systematically searched in six electronic databases, nine relevant guideline databases, and five cancer care society websites. The quality of the included CPGs was assessed by four evaluators using the Appraisal of Guidelines for REsearch and Evaluation, second edition tool. Content analysis was conducted to synthesise the characteristics of the non-pharmacological interventions that were recommended by the included CPGs, such as the intervention’s form, duration and frequency, level of evidence, grade of recommendation, and source of evidence. Results: Fourteen CPGs were identified and analysed. Of the 14 CPGs appraised, only five were rated as high quality. The domain with the highest standardised percentage was “scope and purpose” (84.61%), while the “applicability” domain had the lowest standardised percentage (51.04%). Five guidelines were assessed as “recommended”, seven were rated as “recommended with modifications”, and the remaining two were considered “not recommended”. Regarding the content analysis, physical activity/exercise, meditation, hypnosis, yoga, music therapy, stress management, relaxation, massage, and acupressure were the common self-managed non-pharmacological interventions recommended by the 14 CPGs. Physical activity/exercise was the only self-managed non-pharmacological intervention that was mostly recommended for psychological and physical symptom management by the included CPGs. However, there were significant disparities in terms of level of evidence and grade of recommendation in the included CPGs. Conclusion: The recommendations for the self-managed non-pharmacological interventions were varied and limited among the 14 CPGs, and some were based on medium- and low-quality evidence. More rigorous methods are required to develop high-quality CPGs in order to guide clinicians in offering high-quality and tailored breast cancer survivorship care.

The chromatographic conditions were optimized using headspace gas chromatography, and a simple and rapid method was established for the simultaneous determination of five residual solvents in ursodeoxycholic acid raw materials. The corresponding quality standards were revised. The results showed that the concentration of methanol ranged from 0.06mg/ml to 0.3mg/ml, and the concentrations of acetone, tert butanol, ethyl acetate, and triethylamine showed a good linear relationship with the peak area within the range of 0.1mg/ml to 0.5mg/ml (r=0.999); The quantitation limits for methanol, acetone, tert-butanol, ethyl acetate, and triethylamine were 4.2, 0.9, 1.5, 1, and 0.1 μg/ml, respectively, with detection limits of 1.2, 0.25, 0.025, 0.3, and 0.025 μg/ml, respectively. The recovery rates of each solvent ranged from 92.9% to 106.0%, with RSD% (n=9) less than 3.8%; The method exhibited good repeatability, with RSD% (n=6) less than 2.5%. Furthermore, the durability is good. The established method is simple, accurate, specific, and highly sensitive, and can be used for the simultaneous and rapid determination of five residual solvents in ursodeoxycholic acid raw materials.

Coronavirus disease 2019 (COVID-19) is caused by infection with the 2019 novel coronavirus 2 (2019-nCoV, now referred to as SARS-CoV-2). COVID-19 has become a global pandemic since its outbreak at the end of Dec 2019. COVID-19 could lead to severe acute respiratory disease, especially to those who have reduced immunity. Binding of the viral Spike protein (S) to its receptor ACE2 (Angiotensin Converting Enzyme 2) on the surface of target cells has been proven to be key for virus entry and infection. Although ACE2 expression in the respiratory system is necessary for pneumonia infection by SARS-CoV-2, the regulation of ACE2 gene expression remains poorly investigated, especially for patients that are in pre-pathological conditions. Here, by analyzing The Gene Expression Omnibus (GEO) database, we investigated the expression regulation of ACE2 in various kinds of primary epithelial cells from the respiratory system after varies of respiratory viruses infection such as influenza A virus (IFV), respiratory syncytial virus (RSV) and human rhinovirus (hRV). Our analyses reveal that infection of multiple kinds of respiratory viruses or influenza vaccines greatly increased ACE2 expression, suggesting that respiratory viruses infection could represent a high risk factor for developing COVID-19. We also found that the regulatory effect of influenza A virus on ACE2 expression is associated with activation of the interferon beta-induced pathway and viral RNA-activated host response. Together, our data provide a theoretical framework for clinical classification for SARS-CoV-2 infection susceptibility and could be used for future prevention and therapy treatment for COVID-19.

In this work, we present an analytical model of dynamic power losses for enhancement-mode AlGaN/GaN high-electron-mobility transistor power devices (eGaN HEMTs). To build this new model, the dynamic on-resistance (Rdson) is first accurately extracted by our ex-traction circuit based on a double-diode isolation (DDI) method for a high operating frequency up to 1 MHz and a large drain voltage up to 600 V, thus the unique problem of an increase in the dynamic Rdson is presented. Then the impact of the current operation mode on the on/off transi-tion time is evaluated by a dual-pulse-current-mode test (DPCT) which including a discontinu-ous conduction mode (DCM) and a continuous conduction mode (CCM), thus the transition time is revised for different current mode. Afterward the discrepancy between the drain current and the real channel current is qualitative investigated by an external shunt capacitance (ESC) meth-od, thus the losses due to device parasitic capacitance are also taken into account. After these improvements, the dynamic model will be more compatible for eGaN HEMTs. Finally, the dynamic power losses calculated by this model are verified to be in good agreement with experimental results. Based on this model, we propose a superior solution with qua-si-resonant mode (QRM) to achieve lossless switching and accelerate switching speed.

Earth observation satellites can capture images of specific areas in Earth's orbit based on user requirements. Despite the high demand for satellite imagery, satellites remain a scarce resource. When there are many observation tasks that are large and dense, they may interfere with each other due to satellite mobility. To address this issue, a multi-satellite scheduling algorithm based on a task merging mechanism has been proposed. This paper proposes a two-stage approach to the problem: task merging phase and merging task scheduling phase. The task merging phase introduces two methods based on Mean Shift and Complete Graph to generate the merging task set. In the merging task scheduling phase, a multi-satellite scheduling algorithm based on merging tasks is employed to solve the problem. Finally, certain measurement experiments suggest the effectiveness of the algorithm.

The king ratsnake (Elaphe carinata) of the genus Elaphe is a common large non-venomous snake that is widely distributed in Southeast and East Asia, and is an economically important farmed snake species. As a non-venomous snake, the king snake that is predatory on venomous snakes such as cobras and pit vipers. The immune mechanisms of which has been unclear. Despite their economic and research importance, genomic resources which will benefit studies in toxicology, phylogeography and immunogenetics are lacking. In this study, we use single-tube long fragment read (stLFR) sequencing to display the first complete genome of a King ratsnake from Huangshan City, Anhui province in China. The genome size is 1.56GB with a scaffold N50 of 6.53M, the total length of the genome is approximately 621Mb, and the repeat content is 38.90%. Additionally, we predicted 22,339 protein-coding genes, of which 22,065 had functional annotations. Our genome is a potentially useful addition to those currently available for snakes.

High-performance poly(1,4-butylene terephthalate (PBT) nanocomposites have been developed via the consideration of phosphorus-containing agents and amino-carbon nanotube (A-CNT). One-pot functionalization method has been adopted to prepare functionalized CNTs via the reaction between A-CNT and different oxidation state phosphorus-containing agents, including chlorodiphenylphosphine (DPP-Cl), diphenylphosphinic chloride (DPP(O)-Cl), and diphenyl phosphoryl chloride (DPP(O3)-Cl). These functionalized CNTs, DPP(Ox)-A-CNTs (x = 0, 1, 3), were respectively mixed with PBT to obtain the CNTs-based polymer nanocomposites through a melt blending method. SEM observations demonstrated that DPP(Ox)-A-CNT nano-additives were homogeneously distributed within PBT matrix compared to A-CNT. The incorporation of DPP(Ox)-A-CNT improved the thermal stability of PBT. Moreover, PBT/DPP(O3)-A-CNT showed the highest crystallization temperature and tensile strength, due to the superior dispersion and interfacial interactions between DPP(O3)-A-CNT and PBT. PBT/DPP(O)-A-CNT exhibited the best flame retardancy resulting from the excellent carbonization effect. The radicals generated from decomposed polymer were effectively trapped by DPP(O)-A-CNT, leading to the reduction of heat release rate, smoke production rate, carbon dioxide and carbon monoxide release during cone calorimeter tests.