Acid in-situ leaching (ISL) is a common approach to the recovery of uranium in the subsurface. As some toxic and harmful substances might be produced by the chemical reactions among the injected sulphuric acid, the groundwater, and the porous media during leaching processes, the pollution control of the mining plan for ISL is important. In this study, a three-dimensional reactive transport modeling (3DRTM) was applied to decide the pollution control mining plan, considering the partial penetration through wellbore in confined aquifer and complex chemical reactions between main minerals. Based on the 3DRTM, different pumping ratio and non-uniform injection schemes were compared. The results show that the preferential pollution control mining plan is non-uniform injection ratio equal 0.1. By analyzing the characteristics of water table and streamline, it is concluded that the scheme has a strong hydraulic capture effect. In this scheme, the concentration of UO22+, H+, SO42- obtained by 3DRTM is lower. The inner well injection rate is 194.09 m3/d, the outer well injection rate is 158.89 m3/d, and the pumping rate is 264.00 m3/d. A reasonable suggestion is to adopt non-uniform injection mining mode in ISL.

Biochar has high potential usage in retaining various contaminants, wastewater treatment, and water purification. In this study, three rice husk derived biochars with pyrolysis temperature 300, 400 and 500 ºC, respectively, and pristine rice rusk were used to remove cadmium from aqueous solution. The results showed that about 70% or more of Cd2+ adsorption occurred in the first 960 mins of adsorption kinetics. The Cd2+ adsorption capacity under equilibrium increased with increasing pyrolysis temperature, probably attributed to the increased specific surface area (SSA) under higher pyrolysis temperature noting that significant linear correlation occurred between Cd2+ adsorption capacity and SSA. The Cd2+ adsorption could be best fitted by pseudo-second order model relative to Elovich model and pseudo-first order model. The Cd2+ adsorption rates were higher in film diffusion stage, indicating that film diffusion stage was significant and fast in the early stage of Cd2+ adsorption. In contrast, Cd2+ adsorption by intra-particle diffusion accounted for 47.0%, 47.9% and 43.9% on average of the total Cd2+ adsorption, respectively, indicating that intra-particle diffusion of Cd2+ played a more predominant role in limiting Cd2+ adsorption rate. When reaching Cd2+ desorption equilibrium, removal ratio (RR) values were averaged 0.96, 0.91, and 0.90 under three initial concentrations. More than 90 percentage on average of Cd2+ was removed from aqueous solution by biochars and rice rusk as well, thus biochars can be used to efficiently remove contaminants from aqueous environment. Cation exchange, electrostatic attraction, and the complexation with surface functional groups could be the main dominant mechanisms for Cd2+ adsorption-desorption on biochars.

Building energy consumption is the main urban energy consumption component, which mainly serves people-centered work and living energy demands. Based on the physical requirements of humans in urban buildings and to determine the comfortable body temperature in each season, this paper establishes a sizing optimization model of building-type integrated energy systems (IES), where the cooling and heating loads required to maintain indoor somatosensory body comfortable temperature are calculated. Depending on the external energy price, internal power balance and other constraints, the model develops an optimal sizing and capacity panning method of energy conversion and storage unit in a building-type IES with PV generation. The operating principle is described as follows: the PV generation is fully consumed, a gas engine satisfies the electric and thermal base load requirements, while the power system and a heat pump supply the remaining loads. The gas price, peak-valley electricity price gap and heat-topower ratio of gas engines are considered as important factors for the overall techno-economic analysis. The developed method is applied to optimize the economic performance of building-type IES and verified by practical examples. The results show that using the complementary characteristics of different energy conversion units is important to the overall IES cost.

Polygonatum cyrtonema Hua. is an important medicinal and edible food in China and the traditional processing method of nine-steaming and nine-drying has been used to process its rhizome. However, the global dynamic changes in secondary metabolites during the processing and whether this method could enhance the accumulation of functional components remain unclear. This study aimed to explore the processing-induced mechanisms involved in the accumulation of secondary metabolites and provide theoretical support for the pharmacological study on P. cyrtonema. Results showed the first 6 processing cycles induced drastic changes in the accumulation of secondary metabolites, while the last 3 did not induce further changes. The accumulation of most secondary metabolites significantly increased after the first 3 cycles and stabilized after 6 cycles. The first 3 cycles led to numerous newly added metabolites while the last 6–9 cycles led to a small number of disappeared metabolites. Processing enhanced the biosynthesis of various secondary metabolites and significantly affected the metabolisms of amino acids. Together, a short period of processing was helpful for enhancing the biosynthesis of secondary metabolites. However, the enhancing effects will be reversed or weakened under continuous processing. The processing cycles should be reduced to 3–6 to maintain the enhancing effects.

The CDPK family genes play crucial roles in signal transduction pathways during plant develop-ment and stress response. In this study, we comprehensively analyzed the CDPK family genes in mustard (Brassica juncea L.), resulting in the identification of 101 genes (BjuCDPK1–101) located on chromosomes AA_Chr01 to BB_Chr08. RNA-seq analysis showed that most BjuCDPK genes were predominantly expressed in the root and flower bud, suggesting their organ-specific expression patterns. Furthermore, the expression levels of most BjuCDPK genes were significantly altered by cold stress. The promoter regions of BjuCDPK genes had abundant cis-acting elements related to hormone and stress. The interaction network analysis predicted that BjuCDPK proteins respond to abiotic stress probably via interaction with ABF1, ABF4, and/or DI19. Our findings provide valu-able information for further investigation of the cold stress adaption of mustard via the CDPK signaling pathway.